Praktika T-02(K) turnstile
30
Potential mode of the turnstile is not provided, the card collector shall
be set to pulse mode.
In order to switch into pulse mode:
•
Turn off the power
•
Wait until LED D11 turns off
•
Press and hold BUT1 button on the card collector board
•
Turn on the power;
•
Press and hold BUT1 button until the card collector provides 1
audio signal, indicating that it is switched to pulse mode of
operation;
Set mode is saved when power is turned off. In order to return to the
pulse mode repeat the above sequence.
6.4.3. "Card Inside" contact set (signal for card collection
confirmation).
NC, NO, and COMM contacts. Relay output operating on a "dry
contact" principle which closes / opens for 1 second transmitting a
confirmation signal of card collection to the ACS controller. NC and
COMM - normally closed connection, NO and COMM - normally open
connection.
