Insert barrel nuts (L) all the way into each hole on the bottom of the rear
brace (E). Using a flat head screwdriver (not included),
orient the barrel
nuts so that the grooves are horizontal and pointing towards end of rear
brace.
Lower rear brace (E) into place between the left leg (G) and right leg (F).
Note: Warning label should be facing upwards. Insert two leg screws (K)
with four washers (O) and (N) and repeat on opposite side to attach rear
brace to legs. Tighten all four screws with hex wrench. Note: Split washer
must go on leg screw first.
Insert barrel nuts (L) all the way into each hole on the bottom of the front
brace (J). Using flat head screwdriver, orient the barrel nuts so that the lines
are horizontal and pointing towards end of front brace.
Raise front brace (J) into place between the left leg (G) and right leg (F).
Insert two leg screws (K) with four washers (O) and (N) and repeat on
opposite side to attach front brace to legs. Note: Split washer must go on
leg screw first. Tighten all four screws with hex wrench.
HIGH CHAIR – Base Assembly
4
Summary of Contents for Sprout
Page 4: ...INCLUDED NOT INCLUDED 2 ...
Page 19: ......