ARACHNE 230V – 24V- 12V
Arachne 230V, 24V
and 12V
are brand names of
Oxygen Automation Srl
All rights reserved
GEARMOTOR FOR SWING GATES
ARACHNE
12V-24V-220V
INSTRUCTIONS MANUAL
We congratulate you on the excellent choice entrusted to us. Your new electro-mechanical gearmotor
is manufactured in accordance with high quality and reliability; this will guarantee you performance and
safety over time. In this booklet you will find all the information you need to install your gearmotor and
to protect your safety.
CAUTION IS IN ANY CASE IRREPLACEABLE AND THERE IS NO BETTER RULE TO PREVENT
ACCIDENTS.
All our products are manufactured in accordance with current regulations.
This instruction booklet is intended exclusively for professional
installers who are experts in the
construction criteria and safety and accident protection devices for gates, doors, and motorized gates
(comply with the regulations and laws in force).
- The installer must provide the appropriate explanations and issue the end user with an instruction
manual in accordance with EN 12635.
- Before proceeding with the installation, the installer must carry out a risk analysis of the final
automated closing and safety of the entire system (following EN 12453 and EN 12445 standards).
- The wiring of the various electrical components forming part of the automated closing system (e.g.
photocells, flashing lights, etc.) must be carried out in accordance with EN 60204-1 and the
modifications made by the latter in point 5.2.2 of EN 12453.
- Any repair or adjustment of the equipment is prohibited unless all precautions have been taken to
avoid possible accidents (e.g. power supply disconnected, engine block). All moving parts must be
fitted with appropriate guards.
- The power supply line must be protected for maximum current in blocked rotor condition.
- Install the gearmotor on gates in accordance with EN 12604.
- Have the force measurement developed by the operator carried out and take the measures
provided for in EN 12445.
- Positioning of a possible pair of photocells: the radius of the photocells must be at a height not
exceeding 70cm above the ground and at a distance from the plane of movement of the leaf not
exceeding 20cm. Their correct functioning must be verified at the end of installation in accordance
with point 7.2.1 of EN12445.
- All repair operations must be carried out by qualified personnel.
