Rev.0 LEPTON
Service
manual
OXYGEN S.p.A.
12
REMOVING THE DRIVE
•
Open the battery compartment and disconnect the positive poles (7 - Figure 5)
and the negative poles (8 - Figure 5) (10 mm
2
section) from the battery group;
•
Remove the helmet storage compartment, carefully disconnecting the battery
recharger plug (17 - Figure 5) and the connector of the rear light system (19 -
Figure 5);
•
Cut all the self-blocking bands ;
•
Remove the cooling fan (18 - Figure 5);
•
Cut the heat-restringent covers from the Z10-1 terminals (1 - Figure 5)
•
Disconnect the 3 motor power cables (Black / Red / Green) from the drive
power cables (Black / Brown / Blue), unscrew the 3 connectors so that you can
pull out and disconnect the power wires;
•
Pull out the signal connection cable on the top of the motor flange(4 - Figure 5);
•
Disconnect the ground cable (Yellow / Green) from where it is attached to the
motor casing (2 - Figure 5);
•
Remove the front shield unscrewing the 4 screws (9 – Figure 5). Disconnect the
3 connectors from the electrical system (10 / 11 – Figure 5) and cut the self-
blocking band. These cables are connected directly with the DRIVE. Pull them
with care following their runway site under the frame, in order to preserve the
cable;
•
Disconnect the wires and cables attached directly to the drive:
o
RED wire (10 mm
2
section) from terminal 87 of the switch (12 – Figure
5);
o
BLUE wire drive wire from the yellow wire of the scooter’s electrical
system (16 – Figure 5);
•
Disconnect the cables from the DRIVE plug to the electric recharge system
(21 – Figure 5) ;
•
Remove all the 2 screws of the DRIVE, and remove the DRIVE (0 – Figure
5).
MOUNTING THE DRIVE
•
Place the drive near the motor;
•
Connect the signal cable from the drive in the appropriate connector on the
top of the motor flange (4 – Figure5);
•
Connect the ground cable (Yellow / Green) from DRIVE to the motor casing
(2 - Figure 5);
