ALL RIGHTS RESERVED
2. ELECTRICAL SET-UP (standard system)
1) Motor TYPHON 2000
2) Photocells
3) Key selector
4) Flashing lamp
5) Radio receiver
Fig. 2
3. INSTALLING THE AUTOMATISM
3.1. Preliminary checks
To ensure safety and efficiency of the automated system, make
sure the following requirements are observed before installing
the system:
• The gate structure must be suitable for automation. In
particular the following requirements are necessary:
- The wheel diameter must be in proportion to the weight of the
gate, an upper track must be provided, plus mechanical travel
stops to prevent the gate derailing.
• The soil must guarantee a perfect stability of the foundation
plinth.
• There must be no pipes or electric cables in the plinth
excavation area.
• If the gear motor is located in the vehicle transit or manoeuvre
area, adequate means of protection should be provided against
accidental impact.
• Check if an efficient grounding is available for the connection
to the gear motor.
3.2. MASONRY FOR FOUNDATION PLATE
1- Assemble the foundation plate as shown in figure 05.
2- In order to ensure that the pinion and rack engage correctly,
the foundation plate must be positioned as shown in Fig. 03
(right closing) or Fig. 04 (left closing).
Warning:
The hole for the cables on the foundation plate
must
always point to the gate, see Fig. 05.
3- After determining the position of the foundation plate, make a
plinth as shown in Fig. 06 and wall the plate, providing several
sheaths for routing the cables. Using a spirit level, check if the
plate is perfectly level. Wait for the cement to set.
4- Lay the electric cables for connection to the accessories and
power supply as shown in the diagram of Fig. 02. To facilitate
connections to the control unit, allow the cables to protrude by
at least 45 cm from the hole on the foundation plate.
3.3. MECHANICAL INSTALLATION
1- Remove the cover and position the operator on the
foundation plate, using the supplied washers and nuts. During
this operation, route the cables through the appropriate
openings in the motor body.
2- Adjust the height of the gear motor and the distance from the
gate, referring to the dimensions in Fig.6.
Attention: This operation is necessary to ensure the correct
securing of the rack and to enable any new adjustments.
4- Secure the gear motor to the plate, tightening the nuts.
Fig. 3
160
286
Fig. 4
160
286
Fig. 5
Fig. 6
