ALL RIGHTS RESERVED
4.3. AUTOMATION SYSTEM TEST
Once the installation of the operator has been completed, make a careful functional check of all accessories and safety
devices connected.
Give the Client the “User Guide” and demonstrate the correct operation and use of the gearmotor, highlighting the potentially
dangerous zones of the automated system.
5. MANUAL OPERATION
If it is necessary to manually actuate the gate due to lack of power or
automation interruption, it must be unlocked as follows.
RELEASE LEVER
1) Insert the key supplied in the plastic fold and
open it.
2)Pull the release lever.
3)Open or close the gate manually.
6. RESTORING NORMAL OPERATION
To prevent an inadvertent boost from moving the gate during the manoeuvre, turn off the power supply before locking the
motor again.
RELEASE LEVER
1) Close the release lever.
2) Move the gate until the release system meshes.
3) Close the plastic fold and restore the power supply to the system
7. MAINTENANCE
Check the functional operation of the system at least every six months, especially the efficiency of the safety
devices (including the operator thrust force) and the release devices.
7.1.
OIL FILLING
Periodically check the amount of oil within the operator.
For medium-low frequency of use, an annual check is enough, for more intensive use it is recommended every
6 months. To refill, unscrew the cap and fill up to the indicated level.
8. REPAIRS
For any repairs, contact Norton’s authorised Repair
Centres.
