2 YEAR PRODUCT WARRANTY
Zylux Distribution Pty. Ltd. (ABN 66 101 378 009) of 166 Christmas Street, Fairfield, Victoria, 3078, Australia warrants to the Customer that this product is
substantially free from defects in materials and workmanship under normal use for a period of Two Years from the Date of Purchase. Please ensure you keep a
copy of your purchase receipt on file as this will be required to validate your warranty.
Obtaining Warranty Service:
Within the warranty period, the Customer must contact the authorised supplier / retailer where the product was purchased or alternatively you can contact
the Oz Charge service centre through one of the following methods:
Service help phone: Within Australia (03) 9482 2203
Outside of Australia: +61 3 9482 2203
Website: www.ozcharge.com.au / www.ozcharge.co.nz
If the Authorised Supplier and / or Oz Charge service centre concludes that while under normal use, a product failure or malfunction occurred during the
warranty period and was caused by a defect in material or workmanship (see Exclusions), the Customer will be asked to ship to the nearest service point for
repair or replacement, at our discretion. The product must be packaged appropriately for safe shipment. To prove that the product is under warranty, the
customer should enclose a copy of their receipt for proof of purchase. It is recommended that returned products be sent by registered mail as Zylux
Distribution Pty. Ltd. (Oz Charge) accepts no responsibility / liability for goods lost or damaged in transit.
Exclusions:
If upon receiving a product for repair and if testing and examining the product has disclosed that the alleged defect or malfunction in the product does not
exist or was caused by the Customer or any third persons misuse, neglect, physical abuse, water damage, unauthorised attempts to open, exposure to
extremely high temperatures, tampered with or repaired by an unauthorised persons, this will not be covered under this warranty. Also charges may apply to
any product returned which has no fault found or if the warranty has expired or been void.
This Warranty is also void if:
1. The warranty seal is broken or altered.
2. The warranty period has expired.
3. The product has been tampered with or repaired by an unauthorised person.
4. If used on a generator without using a surge protector.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure. For New Zealand customers, this warranty is in addition to statutory rights observed
under New Zealand legislation.
Owners Manual for OC-RDP. Rev 02.0 - 05/16 - Specifications subject to change without notice.
UNIT DIMENSIONS & MOUNTING TEMPLATE
100mm
75.7mm
115.7mm
13.2mm
Drill a 12mm hole in
this position behind
where the Display
would be mounted
so you can run the
LCD cable with
RJ-12 connector
through the wall
cavity.
Use a small flat
head screwdriver to
remove plastic
covers so the
display can be
screwed into place.
CONNECTING THE DISPLAY TO THE CHARGER
Once the Display has been mounted in position and the LCD cable has been routed to the charger, simply connect the RJ-12 connec-
tor to the socket located above the charger’s DC output cables.
Important Note: Before drilling any holes, please ensure you have checked behind the wall to ensure nothing will be damaged and that
there is sufficient room and clearance so you can route the LCD cable with the RJ-12 connector.
