Drawing 6
4.26.
Installing a fitted stove in a brickwork chimney can be done using flexible piping in its entirety, as indicated in
drawing
7
. We must take special care when sealing the chimney and gas venting to avoid gas blowing back
during storms.
Drawing 7
When installing a flexible tube for gas outlet, be careful that this is not in contact or close to the circuit board
or combustible material.
WI-FI ANTENNA CONNECTION, KEYBOARD, POWER CABLE AND ROOM THERMOSTAT
The stove is supplied with an
OZ Energia
box. This box contains the user manual, the installation and
maintenance manual, a power cable, a room sensor, a cleaning brush, a Wi-fi antenna, a keyboard support and the
keyboard.
We must adjust the screws that secure the keyboard support (
) to the stove
as shown in
drawing 8.
Connect the keyboard connection band (
), which is situated at the back side attached with adhesive tape and
connect it to the back of the keyboard (
). Connection has only one position.
The user has to attach the wi-fi antenna and module to the connection platform (check section
1
of the
tablet manual). The connection platform of the wi-fi antenna is supplied attached to the rear of the hopper.
Stainless steel hose clamp
T of 135° with outlet
Elbow of 45°
Wooden ground
Non flammable floor protection
Stainless steel flexible tube
Rigid flexible pole adapter
Minimum 200mm
It must exceed roof height by 1 metre
If the tube over 4 m in length, the next larger
size will be used
Stainless steel hose clamp
T of 135° with outlet
Elbow of 45°
Wooden ground
Non flammable floor protection
Stainless steel flexible tube
Rigid flexible pole adapter
Anti blow-back seal
Minimum 200mm
It must exceed roof height by 1 metre
If the tube over 4 m in length, the next larger
size will be used
26