5.2.
Ash in the fireplace
When opening the door, you reach the burn pot where combustion takes place; hoover it and remove it
(make sure you’ll put it back properly) in order to clean all holes; make sure they’re clean and hoover the
support of the burn pot as well.
Drawing 11
5.3.
Fireplace door
Clean the glass with a towel, using a liquid for glass cleaning, always when cold.
Optionally there is a glass cleaner; see the exploded view of the stove.
Check locking system periodically, adjusting it as necessary to avoid loss of the hermetic seal in the
combustion chamber.
5.4.
Ash box
In models in this manual, you can access to the ash box by opening the door of the fireplace.
Ash box
Drawing 12
IMPORTANT:
If the stove is operating while full of ash or residues, that might stretch the burn pot and its
support, the ash box and even the burn pot, being the cause of bad operation or possible breakdown.
MAINTENANCE AT END OF SEASON OR EVERY 500 KG OF FUEL
This is necessary to ensure correct operation and maintain the stove’s life duration. When winter ends,
contact your provider (if he did not contact you) and meet to carry out this maintenance; the following shall be done
(the stove must always be disconnected from power):
5.5.
Opening the sides.
CAUTION! (WE MUST UNPLUG THE STOVE BEFORE PERFORMING THIS OPERATION).
Remove two screws on each side of the stove, which are located on the front of the liner.
5.6.
Cleaning the fireplace
In addition to daily cleaning carried out with great attention, the following items must be cleaned:
Heat exchanger pipes. By activating the drawers of the rake. If you have a
5,5kW
or a
7kW
stove model,
remove the top plate of the fireplace as indicated in section
5.1.
Burn pot.
Burn pot support.
Ash box.
Screws of Mobile parts.
Air entrance pipe.
28