Figura 6
4.26.
A instalação numa chaminé de obra pode ser feita, na totalidade, em tubo flexível, tal como indicado na
figura 7.
Deve-se ter especial cuidado ao efectuar o isolamento entre a chaminé e o tubo da saída de gases para
evitar possíveis retrocessos de gases em caso de tempestade.
Figura 7
Ao instalar o tubo flexível para a saída de gases, prestar especial atenção para que não fique em contacto ou
próximo da placa electrónica ou de material combustível.
LIGAÇÃO DA ANTENA WI-FI, CABO DE ALIMENTAÇÃO E TERMÓSTATO DE AMBIENTE
No interior da embalagem do equipamento encontra-se uma caixa
OZ Energia
que contém o manual do
utilizador, manual de instalação e manutenção, cabo de alimentação, sonda de ambiente, escova de limpeza, antena
wi-fi, teclado e suporte de teclado.
Devem-se ajustar os parafusos que fixam o suporte à estufa(
),como se indica na
figura 8,
ligar a fita plana
de ligação do teclado (
), que está na parte traseira, presa com uma fita adesiva, e ligá-la ao teclado (
); só tem
uma posição de ligação.
Deve-se montar a antena wi-fi e o módulo no local de encaixe (ver parágrafo
1
do manual do utilizador). O
encaixe da antena wi-fi encontra-se na parte de trás do reservatório.
Abraçadeira de união de aço inox
T de 135° com registo
Curva de 45°
Chão de madeira
Protector de chão ígnifugo
Tubo de aço inox flexível
União adaptadora de flexível a rígido
Mínimo 200mm
Deve ultrapassar o tecto em 1 metro
Superior a 4 m, aumenta-se uma medida
Abraçadeira de união de aço inox
T de 135° com registo
Curva de 45°
Chão de madeira
Protector de chão ígnifugo
Tubo de aço inox flexível
União adaptadora de flexível a rígido
Isolante anti-retrocesso
Mínimo 200mm
Deve ultrapassar o tecto em 1 metro
Superior a 4m, aumenta-se uma medida
8