7
© Oz inventions
Version 1.8
Provided items
Receiver-Modulator
Antenna (optional)
DC 12 volt 150mA power supply (optional)
one meter TRS cable (optional)
Quick start manual (optional)
Safety and care
Remove power from all devices to be connected before connecting or disconnecting
Dismantling the device may damage the device. There are no user serviceable parts inside the
device.
Only use the provided AC to DC power adapter or other certified adapter. Only use the correct
polarity of the provided reversible DC power adapter. Negative centre (tip) is the correct polarity.
The power adapter is supplied in the correct configuration. Do not reverse the connection.
Electromagnetic radiation is minimised by the aluminium enclosure and relevant internal
components. However, should interference be experienced, position the device further away from
the device that is interfering or being interfered with. Interference can also be limited by operating
the device on different radio frequency channels.
Due to the nature of modulation, some modulated parameters, particularly at the ends of
modulation, can cause a loud and/or irritating audio signal. The default setting is to reduce the
modulating output to zero if radio contact is lost with the transmitter. However, this setting can be
defeated, and does not apply to all modes of operation, which could result in a permanent loud
and/or irritating audio signal until the modulation on/off control can be actuated. Permanent high
volume audio signals can damage hearing and equipment.
Should the device malfunction, a reboot or restore to default settings, may resolve the problem.
Otherwise the manufacturer should be contacted. There are no user serviceable parts inside the
device.
Avoid contact with, and environments, known to cause adverse effects with electronics and small
moving parts, such as liquids, dust, sand, high humidity, high temperature and vibrations.
Avoid excessive force when operating controls and connecting cables
Disconnect the device during lightning storms and /or times of power outages
This modulating device is designed to be connected to another device that outputs a DC voltage no
greater than 5 volts. Damage can be caused to this modulating device if greater than 5 volts is
applied to the expression socket. Consideration must be taken when connecting and using it.
If in doubt contact Oz inventions at
contact@ozinventions.com