Take note of the following regarding inspections.
• Brakes require more than audible and visual inspection. Check daily by operating with and without a load,
stopping at various positions to ensure safe operation. If the load coasts or creeps contact the factory for
friction disc replacements.
• Proper inspection may require disassembly of some parts. Contact the factory before doing so or the
applicable warranty may be voided.
• For wire rope inspections please contact the specific manufacturer of the rope. The inspection provided in
the chart below is for a general inspection only and is in no way the complete inspection required.
• Before operation assure all deficiencies on the inspection chart are resolved and inspections are up to
date. Refer to troubleshooting chart for further assistance.
Inspection Chart
Frequent Inspection (F) and Periodic Inspection (P)
Location
Check For
F
P
General
Paint chipping or excessive wear
X
Damage, cracks, rust, dents excess wear, or corrosion.
X
Unusual sounds
X
Smooth load movements
X
Winch lubricated
X
Signs of overloading (cracks, dents, or damage)
X
Proper function when operated with a load equal to the load rating
X
Foundation
Good condition/Supports the winch under all conditions
X
Cracks, corrosion, damage
X
Brake Assembly
Ratchet pawl clicks firmly as handle is turned clockwise
X
Proper operation
X
Corrosion, cracks, damage, or wear
X
Fasteners
Firmly installed
X
Properly tightened
X
Stripped threads, bent, or damage (check by removing winch from the foundation)
X
Gears, bearings, shafts
Excess wear, cracks, corrosion, or damage
X
Well lubricated
X
Handle
Rotates freely in both directions
X
End Connections
Corrosion, excess wear, rust, or damage
X
Attached firmly
X
Drum
Excess wear or distortion of anchor hole
X
Excess movement due to misaligned gears, bearings, shafts (check by moving the drum by hand)
X
Load Hook
Bent, twisted or damaged
X
Hook latch doesn’t close when released
X
Securely attached to wire rope with no fraying or damage to the rope
X
Frame
Bent, cracks, or damage (signs of overloading)
X
Wire rope
Installed correctly
X
Wound tightly and evenly on drum
X
No visible damage to entire rope
X
Labels
Not been removed, altered, or obscured (Contact factory for replacements)
X
EN pg.10
