12
SAFETY NET
Step 5a
Once all poles are inserted and net T pieces and straps
are on, stand each pole up and attach with 2 clamps
to the U shape leg as per the picture, noting that the
rounder edge of the clamp should be facing outwards.
– at this stage screw the clamps on loosely to allow some
flexibility for later steps.
Tip: As you attach both clamps, take care to ensure they
are aligned with one another to avoid warping the safety
poles.
Step 5b
As you tighten and clamp each pole, ensure each side of
the safety net/enclosure is sitting below or underneath
the edge of the frame.
Step 6
Place all net rods into upper horizontal net sleeves. Then
secure each net rod into the black net T pieces at the top
of the metal net poles.
Please note the fiberglass poles are not all the same
length.
The poles marked with Yellow tape need to be used in
the middle of the long side of the trampoline (above the
entrance and opposite the entrance. You will notice that
the cords on the sleeves where the T piece sits are yellow
as well.
10x15 Trampolines you need 2 poles to make up one
section between the T pieces – the joiners are supplied in
your boxes.
Tip: As you get to the last few poles, it can get tight so
pull the pole towards you to allow the pole to go into the
T piece.
