7
8
Safety Pads Assembly
Installation Time
You should allow approximately 20 minutes for this stage.
Step 1
Lay the Safety Pads on top of the trampoline,
aligning the pad section joins with the joins in
the frame.
Kneeling on the inside of the trampoline, feed the
Elastic Toggles through the two eyelets so the
loop end of the tie faces outwards and the toggle
end is on the inside.
Step 2
Using a flat-head screwdriver (or similar), push
the loop end between the wall panel and frame.
From underneath, insert the toggle into the loop
and rotate to secure. Repeat for all ties.
Handy Hint
To create a gap between the wall and frame, you
may need to insert your flat-head screwdriver and
rotate to create a gap.
Step 3
To finish installing your pads, remove a single
spring underneath where each pad section joins
the next one. Then insert the spring through the
loop on the underside of the pad and re-attach
the spring. This will stop the front of the pads
lifting up.
Enclosure Parts
Full Enclosure Assembly
Enclosure Poles
Quantity (Full Enclosure): 8
Quantity (Half Enclosure): 4
Sleeved Netting
with Foam Inserts
Quantity: 1
