9
10
Full Enclosure Assembly
Step 1
Take the Enclosure Net complete with foam inserts and lay flat on the trampoline mat with the zip entrance facing
towards you.
Step 2
Insert two enclosure poles into the sleeves on
either side of the zip in positions 1 and 2 of this
diagram. Then insert 2 further poles opposite
the first two, in positions 5 and 6.
(Refer to the image on Page 8)
Step 3
Insert each of the poles into the correct
enclosure sockets through the 10cm slot
between the pad sections.
Step 4
Finally with the enclosure now half-assembled and upright, insert the remaining poles into the sleeves in
positions 3, 4, 7 and 8 and then into the enclosure sockets. The bottom of the net runs along the vented pads
and is not tied off in anyway.
Half Enclosure Assembly
Step 1
Take the Enclosure Net complete with foam inserts and lay flat on the trampoline mat.
Step 2
Insert all enclosure poles into the sleeves.
Step 3
Insert each of the poles into the enclosure sockets
(on which ever side you want the net) through the
10cm slot between the pad sections.
Congratulations!
Your trampoline is now ready to be used. Enjoy!
Please familiarise yourself with the safety and maintenance tips
located at the start of the manual.
