1
RHD-6100
4. OPERATING THE HAMMER DRILL
4. To start drilling squeeze
the On/Off switch.
5. To stop drilling release
the On/Off switch.
NOTE:
PRIOR TO CHANGING MODES, THE ON/
OFF SWITCH SHOULD BE RELEASED AND THE
DRILL SHOULD HAVE COME TO A COMPLETE
STOP.
1. Choose an
operation mode:
Hammer Drill
Rotate the side mode selector to the hammer and drill icon,
and rotate the rear mode selector to the drill and hammer icon.
This setting is recommended for use when drilling holes in
concrete and other masonry products. The hammer action will
be in operation while simultaneously the drill bit rotates.
Chiselling
Rotate the side mode selector to the hammer icon, and rotate the rear
mode selector to the drill and hammer icon. This setting is recommended
for use when you desire a hammer action without the accessory rotating
which is ideal for “chiseling or chipping” away at masonry products, pick
or chisel accessory bits should be used.
Drilling
Rotate the side mode selector to the hammer and drill icon, and
rotate the rear mode selector to the drill icon. This setting is
recommended for use when you desire the accessory to rotate
without hammer action. Ideal for drilling into timber or steel when
correct accessories for such materials are used.
OPERATION
2. Ensure your workpiece is securely clamped where possible.
3. Connect the tool to the mains power supply.
