6. CLEANING & MAINTENANCE
OPERATION
IMPORTANT!
BEFORE CLEANING YOUR COMPRESSOR
OR CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THAT THE MOTOR IS OFF AND THE TOOL
DISCONNECTED FROM THE POWER SUPPLY TO PREVENT
ACCIDENTAL STARTING.
IMPORTANT!
WAIT UNTIL THE COMPRESSOR HAS
COMPLETELY COOLED DOWN. RISK OF BURNS!
IMPORTANT!
ALWAYS DEPRESSURIZE THE EQUIPMENT
BEFORE CARRYING OUT ANY CLEANING AND
MAINTENANCE WORK.
Cleaning
• Keep the safety devices free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed
air at low pressure.
• We recommend that you clean the appliance immediately
after you use it.
• Clean the appliance regularly with a damp cloth and some soft soap.
Do not use cleaning agents or solvents; these may be aggressive to
the plastic parts in the appliance. Ensure that no water can get into
the interior of the appliance.
• You must disconnect the hose and any spraying tools from the
compressor before cleaning. Do not clean the compressor with
water, solvents or the like.
5. TROUBLE SHOOTING
Problem
Cause
Solution
The compressor
does not start
No supply voltage
Check the supply
voltage, the power
plug and the socket-
outlet.
Insufficient supply
voltage
Make sure that the
extension cable is
not too long.
Try another product
in power point
Outside temperature is
too low
Never operate
with an outside
temperature of
below 5°c.
Motor is overheated
Allow the motor
to cool down. If
necessary, remedy
the cause of the
overheating.
The compressor
starts but there is no
pressure
The seals are
damaged.
Check the seals
and have any
damaged seals
replaced by a
service centre
The compressor
starts, but the tools
do not .
Loose hose
connections
Check the
compressed air
hose and tools
and replace if
necessary.
Leak in a quick-lock
coupling
Check the quick-
lock coupling
and replace if
necessary.
MAINTENANCE
