12
operation
Ensure workpiece is clamped securely so that it will not move
1.
during the cut. (Fig. 14)
Plug your biscuit joiner into the power supply and prepare to make your first cut.
2.
Firmly grasp and hold your biscuit joiner with both hands using
3.
the assist handle (12) and rear handle (15). (Fig. 15)
Place the fence (7) flush against the workpiece and align
4.
the centreline indicator (6) on the fence (7) with the biscuit
centreline mark on the workpiece. (Fig. 16)
Push safety lock-off switch (1) forward and depress the trigger
5.
switch (1). (Fig. 17) Allow your biscuit joiner to reach maximum
speed and then push it forward to extend the blade into the
workpiece.
When the depth stop (9) bottoms out against the depth
6.
adjustment knob (9) (Fig. 18), pull back releasing pressure on
the spring. Blade will retract from biscuit slot. Release trigger
switch (1) to turn off your biscuit joiner.
Fig. 16
Fig. 15
Fig. 14
Fig. 18
Fig. 17
