Ozito BSR-1000, Operation Manual

INTRODUCTION

3

Congratulations on purchasing an Ozito Belt Sander.
We aim to provide quality tools at an affordable price.

We hope you will enjoy using this tool for many years.
Your Belt Sander BSR-1000 has been designed for (what
is it designed for) and is intended for DIY use only. 

Warning!

When using mains-powered equipment, basic safety

precautions, including the following, should always be followed to reduce
risk of fire, electric shock, personal injury and material damage.

Read and understand the manual prior to operating this tool.

Save these instructions and other documents supplied with this tool for future reference.

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note:

The supply of 230V and 240V on Ozito tools are interchangeable for

Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS 60745-1; therefore
no earth wire is required.

If the supply cord is damaged, it must be replaced by a qualified electrician or a
power tool repairer in order to avoid a hazard.

Note:

Double insulation does not take the place of normal safety precautions when

operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric shock.

ELECTRICAL SAFETY

!!

!!