Ozito BSR-1000, Operation Manual

7

OPERATION

Attaching the Dust Bag to The Belt Sander

Attach the dust bag (7) to the belt sander by sliding the plastic dust bag adaptor
over the dust ejection port on the left hand side of the belt sander beside the rear
soft grip handle (1).

BE SURE TO DISCONNECT THE BELT SANDER FROM THE POWER SUPPLY
BEFORE INSTALLING OR REMOVING THE SANDING BELTS.

Removing and Installing Sanding Belts

TO REMOVE BELT

1. Place the belt sander on it’s left hand side on a flat

surface. Pull out the belt tension release lever (9).
Push it towards the front of the sander until it locks
into place. The front roller retracts and locks into
place releasing the belt tension.  

2. With the belt sander remaining on its left side

gently slide out the belt off the unit (Fig.2). 

3. Use both hands easing both sides simultaneously. 

TO INSTALL A BELT

1. When installing a belt to your belt sander ensure 

you have the correct size sanding belts and grit for
your work piece. Belts also have markings on them 
of arrows which are a direction markings to assist in
fitting the belt to your belt sander and a grit rating
that relates to how coarse the sanding belt is (Fig. 3).
While the belt sander is on it’s left side with the 
belt tension release lever (9) locked, gently place 
the belt over the front and rear rollers. The arrows 
on the belt are to be aligned with the marking on
the belt sander (Fig. 4). This is very important as if
the belt is fitted in the incorrect direction the belt 
will break. Please note that belts are not covered
under warranty. 

2. Once the belt is in place, return the belt tension release lever (9) back to its

original position.  

Fig.1

Fig. 2

Fig. 3

Fig. 4

ASSEMBLY