MAINTENANCE
15
Chain Sharpening
The chain (6) on the CSE-355 chainsaw can be sharpened using a 5/32" size file.
A sharp chain generates wood chips during the cut, a dull chain generates
sawdust powder and produces a slow cut.
Chain sharpening requires special tools. Chain sharpening tools can be purchased
at your local Bunnings Warehouse. Alternatively you can take the chain to a
professional chain sharpener.
Further Maintenance
After each use, blow air through the chainsaw housing to ensure it is free from all
wood chips and saw dust that may build up.
If the enclosure of the chainsaw requires cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get inside the chainsaw; never immerse any
part of the chainsaw into a liquid.
When the carbon brushes wear out the chainsaw will spark and/or stop. The
brushes are a wearing component of the chainsaw and should be replaced prior to
the carbon wearing out fully. Brushes will wear out after many uses but before they
do, contact Ozito customer service for quick replacement.
Always replace both brushes at the same time.
• Keep the ventilation vents of the chainsaw clean at all times, if possible,
prevent foreign matter from entering the vents. Build up of dust particles may
cause the chainsaw to overheat and fail.
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the tool by an unauthorised person or by mishandling of the tool.
Limited spare parts are available subject to availability. Please contact your local
Bunnings Special Orders Desk to order the required spare parts.
Most common spare parts listed below
Spare Part
Part No.
Bar Securing Nut Cover
SPCSE355-10
Chain
SPCSE355-17
Chain Plate
SPCSE355-18
Brush Cover (Pair)
SPCSE355-3315
Carbon Brush (Pair)
SPCSE355-3316
SPARE PARTS
