DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquiries@ozito.com.au
SPARE PARTS
Read instructions
Wear safety glasses
Beware of kickback
Regulator compliance mark
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
/min
Revolutions or
reciprocation per minute
Double insulated
n
o
No load speed
Warning
Diameter
Do not expose to rain
Wear muffs
Always hold the saw with
Disconnect and discontinue use should the power cord be damaged
both hands
Sound power level
Ø
108
52
IMPORTANT!
When placing the chain on the guide bar,
ensure the chain direction is the same as the image on
the guide bar
Chain drive links 52
Chain Replacement:
The chain can be purchased through Ozito spare parts or from your
local Bunnings Warehouse. The correct chain can be purchased by
matching the pitch, gauge and number of links as shown below:
2
9.53
mm
(3/8)
1.3
mm(
.050”)
52
Links
2
2
TROUBLESHOOTING
PROBLEM
CAUSE
REMEDY
Chainsaw will not
work.
Chain brake
engaged
Disengage brake
No power supply
Defective mains
outlet
Try alternative
source of electrical
power
Power extension
cord damaged
Check the cable and
replace if required
Chainsaw operates
intermittently
Power cable
damaged
On/Off switch
defective
Dry chain
No oil in oil tank
Fill oil tank with
chain bar oil
Oil tank cap breather
blocked
Clean oil tank cap
Oil outlet blocked
Clear oil outlet
Chain or guide rail
hot
No oil in oil tank
Fill oil tank with
chain bar oil
Oil tank cap breather
blocked
Clean oil tank cap
Oil outlet blocked
Clear oil outlet
Blunt chain
Sharpen or replace
chain
Wont cut
Blunt chain
Sharpen or replace
chain
Chain on backwards
(chain teeth pointing
in the wrong
direction)
Remove chain and
reinstall with the
teeth facing in the
correct direction
Worn chain
Replace the chain
Chainsaw vibrating
or not cutting
properly
Chain tension too
loose
Adjust chain to
correct tension
Blunt chain
Sharpen or replace
chain
Worn chain
Replace the chain
Chain on backwards
(chain teeth pointing
in the wrong
direction).
Remove chain and
reinstall with the
teeth facing in the
correct direction
Gauge
Read the operating instructions.
Wear safety goggles.
Safety class II
Never expose the
device to rain
Wear ear protection
If the cable is damaged or cut, disconnect the power plug from
the mains immediately.
Maximum cutting length / chain speed vu: 13.5 m/s
