Ozito GGC-015, Instruction Manual

This glue gun has been designed so that it can be used as either a corded or cord
free unit. 

The glue gun can be used continuously when
connected via the cord to a 240V power source (Fig.1). 

Alternatively, placing the glue gun in the stand to heat
the element between 5-8 minutes, will allow you to use
the glue gun cord free for up to 5 minutes. 

Loading the Glue Stick 

1. Insert the glue stick into the entry hole of the glue gun and squeeze the trigger

flow control (5) to further load the glue stick into the glue gun. 

Note: 

If there is no glue released from the nozzle, you

may need to insert another glue stick.

2. The glue may stop flowing when there is

approximately a 1/4 left of the glue stick sitting out
of the entry hole  (Fig. 2).

3. Insert another glue stick and push the existing one

in. Then push the trigger flow control (5).

Heating the Glue Stick 

1. Ensure the glue gun is sitting in the charging stand (6). 

2. Connect the power cord to the glue gun (Fig. 3).

Then plug the cord to the mains power outlet. The
LED indicator lights (3) will turn red once it is
connected.

3. Allow the glue gun to heat up on the charging

stand (6) for 5 - 8 minutes before use.

OPERATION

7

Fig.

2  

Fig. 3  

Fig. 1