MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• When not in use, the Hedge Trimmer should be stored in a dry, frost free
location not within the reach of children.
• Keep ventilation slots of the Hedge Trimmer clean at all times and prevent any
foreign matter from entering.
• If the enclosure of the Hedge Trimmer requires cleaning do not use solvents
but a moist cloth only.
• There are no user serviceable parts in the Hedge Trimmer; if a fault is
suspected or the supply cord requires replacement, return the Trimmer to a
power tool repairer.
• The blade rail should be cleaned and treated with light machine oil or spray
lubricant (such as WD40, CRC 5.56 or RP7) after each use. When a job lasts
for a longer period of time it is recommended that the blade rail also be treated
with spray lubricant at regular intervals during operation.
Carbon Brushes
When the carbon brushes wear out, the hedge trimmer will spark and/or stop.
Discontinue use as soon as this happens. They should be replaced prior to
recommencing use of the hedge trimmer. Carbon
brushes are a wearing component of the hedge
trimmer therefore not covered under warranty.
Continuing to use the hedge trimmer when carbon
brushes need to be replaced may cause permanent
damage to the hedge trimmer. Carbon brushes
will wear out after many uses but when the carbon
brushes need to be replaced, take the hedge trimmer
to an electrician or a power tool repairer for a quick and low cost replacement.
Always replace both carbon brushes at the same time.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the hedge trimmer by an unauthorised person or by
mishandling of the hedge trimmer. This tool is designed for DIY use - use in
commercial or industrial environments will void the warranty.
Blade
Cover
SPHTE550-54
Carbon Brush (Pair)
SPHTE550-34
Brush Holder (Pair)
SPHTE550-32
Blade
SPHTE550-56
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquires@ozito.com.au
SPARE PARTS
V
Volts
Hz
~
Alternating current
W
/min
Revolutions or
reciprocation per minute
Double insulated
n
o
Warning
Wear eye protection
Regulator compliance mark
Read instruction manual
Disconnect the mains plug
if the cord is damaged
or entangled
Decibel level
Do not operate in the rain
Danger flying objects
Hertz
Watts
No load speed
100
Problem
Cause
Remedy
Blades are not
cutting smoothly.
Blades could be
worn or damaged
Contact customer service.
Excessive
sparking visible
through air vents
Carbon brushes
may have worn
out
Replace carbon brushes as
per maintenance section.
WARNING!
ENSURE THE HEDGE TRIMMER IS
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
