I
0
AC 240V ~ 50Hz
OFF
ON
AC POWER
ON
THERMAL
OVERLOAD
ALLOW
WELDER
TO COOL
DOWN
!
100A
INVERTER
MIG WELDER
VOLTAGE
MIN
MAX
FEED RATE
MIN
MAX
Safety Precautions
• Read all safety warnings and all instructions before use. Failure
to follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
• Always wear appropriate protective equipment when welding.
These include: welding helmets, overalls, welding gloves, closed
shoes, leather apron, sock protectors. Overalls should be of the
type designed to be buttoned at the wrists and the neck.
• Remove loose clothing and accessories and ensure any loose
hair is tied up or tucked away.
• Toxic gases are given off during the welding process, which
may collect in the welding area. Always ensure to weld in a
well-ventilated area and use a fume extractor when required.
• The electric arc generated by the welding process gives direct
heat and ultraviolet radiation. It is essential that the eyes of
the operator and any bystanders are protected from the glare
during welding. ALWAYS use a face shield or welding helmets
fitted with the correct glass filter.
• Inspect the welder, welding torch and all connecting wires for
damage / worn insulation before each use and if any damage is
found, replace the damaged parts before use.
• Parts of the welding torch and welding material can be
extremely hot immediately after welding. Wait for the electrode
and the material to cool down before handling and always
ensure welding gloves are worn when handling hot materials.
WARNING!
ENSURE ALL OIL, PETROL AND
FLAMMABLE CONTAINERS HAVE BEEN REMOVED
FROM THE WELDING AREA.
1. On/Off Switch
2. AC Power Cord
3. Power ON LED
4. Thermal Overload LED
5. Voltage Control Dial
6. Feed Rate Control Dial
7. Torch
8. Earth Clamp
9. Torch Tip
10. Torch Shroud
SELF SHIELDED FLUX CORED INVERTER ARC WELDER
KNOW YOUR PRODUCT
1. BEFORE STARTING
SETUP & PREPARATION
4
8
3
7
1
10
9
2
5
6
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
