Installing A Wire Spool
The welder can be fitted with 0.8mm or 0.9mm gasless welding
wire. Welding wire up to 1kg can be fitted to this welder.
1. Push the latch towards the back of the
welder unit and lift the top cover.
2. Undo the spool nut then
remove the spring and spool
plate.
Note:
Before first use, be sure to
remove all the packaging from
the included wire spool.
WARNING!
DO NOT PULL THE END OF THE WIRE FREE
UNTIL YOU ARE READY TO THREAD THE MACHINE. THE
SPOOL IS COILED UNDER TENSION AND WILL UNWIND
IF RELEASED WHICH MAY CAUSE TANGLING & WIRE
FEED ISSUES DURING USE.
3. Place the spool onto the
spindle so that the wire
unwinds in an anti-clockwise
direction.
4. Replace the spool plate and
spring, then lock it in place
with the spool nut.
5. Flip the tension adjustor bar
up and swing the pressure
arm away from the roller
guide.
6. While maintaining a firm hold
of the wire end, pull it free of
the spool and thread it through
the feed tube and into the
cable housing.
7. Rotate the pressure arm back
into place and flip the tension
adjustor bar back to lock it in
place.
Assembling The Welding Mask
The included welding mask must be fitted with the lens assembly
and handle before using it for welding.
1. Push the plastic pins into the
mask from the outside and
secure it with the retaining
clips from the inside of the
mask. Rotate the retaining
clips so that the lens assembly
can be inserted.
2. Insert the clear glass into the
recess of the welding mask,
then the dark safety glass and
finally the plastic lens frame.
3. Rotate the retaining clips to
lock the lens assembly in
place.
4. Bend the sides and top of the
welding mask inwards and
clip it together at the corners.
5. Insert the 3 screws into the
handle mounting holes from
the outside. Fit the handle onto
the screws on the inside of the
mask and secure them using
the 3 nuts.
2. ASSEMBLY
3. SETTING UP THE WELDING WIRE
WARNING!
ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
WARNING!
ALWAYS ENSURE THE WELDER IS
SWITCHED OFF WHEN REPLACING THE WELDING WIRE
&/OR MAKING ADJUSTMENTS TO THE WIRE DRIVE
SYSTEM.
a
b
a
b
