MAINTENANCE
Cleaning
1. We recommend that you clean the tool immediately after you use it.
2. Keep the device free of dirt and dust as much as possible. Wipe the
equipment with a clean cloth.
Storage
Pull the mains plug out of the socket, switch off the tool and make
sure that it is secured in such a way that it cannot be started up again
by any unauthorised person.
Store the tool in a dry location which is not accessible to unauthorised
persons.
Supply Cords
If the supply cord of this power tool is damaged, it must be
replaced by a specially prepared cord available through the service
organisation.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the tool by an unauthorised person or
by mishandling of the tool.
WARNING!
BEFORE CLEANING OR CARRYING OUT
ANY MAINTENANCE PROCEDURE, MAKE SURE
THAT IT IS DISCONNECTED FROM THE POWER
SUPPLY TO PREVENT ACCIDENTAL STARTING.
Sanding Tips
Never force the material into the sander; allow the sandpaper to do
the work. Applying additional pressure will slow the motor, rapidly
wear the sandpaper, and greatly reduce the sander speed. This will
slow the removal rate and produce an inferior quality surface.
WARNING!
EXCESSIVE PRESSURE WILL
OVERLOAD THE MOTOR, CAUSING OVERHEATING
AND POSSIBLE DAMAGE TO THE MOTOR AND/OR
DAMAGE TO THE SURFACE.
Be sure to check your workpiece often. The sander is capable of
removing material rapidly, especially with coarse paper.
Do not sand on one spot for too long. The sander’s rapid action may
remove too much material, creating an uneven surface.
WARNING!
WHEN SANDING SOFT METALS, THE
MATERIAL CAN GET HOT. SAND WITH CAUTION
AND IF NECESSARY, COOL THE MATERIAL DOWN
BEFORE RESUMING SANDING OPERATIONS.
WARNING!
DUST EXTRACTION SHOULD NOT BE
USED DURING METAL SANDING TO PREVENT
HOT METAL FRAGMENTS FROM ENTERING
THE VACUUM CLEANER OR DUST EXTRACTION
SYSTEM.
WARNING!
BEFORE COMMENCING METAL
SANDING, THE SANDER AND WORK AREA MUST BE
CLEANED THOROUGHLY TO REMOVE ANY WOOD
DUST & RESIDUE.
