14
Problem
Cause
Remedy
No coating material
is coming out of
the nozzle
The nozzle is blocked
Clean
The suction tube is blocked
Clean
The small hole in the suction tube
is blocked
Clean
Material spray regulator dial turned
too far to the (-)
Turn to the (+)
The suction tube is loose
Tighten pipe
No pressure is built up in the paint pot
Tighten paint pot
The coating material
drips from the nozzle
The nozzle is loose
Tighten
The nozzle is worn
Change
Build up of coating material in the air
cap and nozzle
Clean
Spray too coarse
Coating material has a too high viscosity
Dilute
Too much material, spray regulator dial
turned too far to (+)
Turn spray regulator dial
to (-)
Nozzle dirty
Clean
Air filter very dirty
Change
Not enough pressure built up in paint pot
Tighten paint pot
The spray jet pulses
Coating material in paint pot is
running out
Refill
The small hole in the suction tube
is blocked
Clean
Air filter very dirty
Change
Run in the coating
material
Too much coating material applied
Turn the material spray
regulator dial to the (-)
Too much coating
material mist
(overspray)
The distance to the object to be
sprayed is too large
Reduce spraying distance
Too much coating material applied
Turn material spray regulator
dial to the (-)
TROUBLE SHOOTING
Summary of Contents for MPS-700
Page 1: ......
