2. LOADING NAILS
3. CONTROLS
OPERATION
The tool is recommended for use with a residual current
device with a rated residual current of 30mA or less.
1. Squeeze the magazine latch and pull the magazine away from the
tool.
3. Close the magazine, ensuring it clicks into place.
2. Insert a row of nails into the second track of the magazine. The
nails should be flush against the inner chamber.
To fire the nail and
staple gun, squeeze
the on/off trigger.
1. To supply the tool with
power, flick the power
switch to the “I” position.
Power Switch
On/off Trigger
Variable Depth Adjustment Dial
2. To turn off, flick the power
switch to the “0” position.
The variable depth adjustment dial allows you to control the depth
at which the nail gun fires a nail or staple.
To increase depth,
turn the variable depth
adjustment dial toward the
“+” symbol.
To decrease depth, turn
the dial to the “-” symbol.
Note:
IF THE MAGAZINE WILL NOT CLOSE, THE
MAGAZINE MAY BE OVER CAPACITY. REMOVE SOME
NAILS/ STAPLES THEN TRY TO CLOSE AGAIN.
1. To find the correct depth
setting, fire a nail into a
scrap piece of material.
2. Adjust the dial and fire
another nail. Repeat until
the nail is driven flush with
the work surface