Charging The Tool
1. Flip open the dust cover on the charging port.
2. Plug the USB C cable into
the charging port and
connect the other end to a
USB charging port/adaptor.
3. Use the LED charge indicator
lights to monitor the
charging status.
Approximate charge
percentages:
1 LED: 35%
2 LEDs: 70%
3 LEDs: 100%
Note:
charging time will depend on the output of the charging
source.
WARNING!
NEVER OVERCHARGE THE TOOL. NEVER
CHARGE THE SCREWDRIVER UNSUPERVISED.
4. Remove the cable and cover the charging port with the dust
cover.
1. Charging Port Dust Cover
2. Charge Indicator LEDs
3. Drive Mode Collar
4. Magnetic Chuck
5. Forward/Off/Reverse Switch
6. Speed Control Dial
3.6V LI-ION SCREWDRIVER
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
1
5
6
3
4
2
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.