Ozito OSG-120K, Instruction Manual

7

PREPARATION & SETUP

WARNING!

Failure to unplug your orbital sander could result in accidental

starting causing possible serious injury.

Attaching Sandpaper

Your sander has a base plate (8) size of (187x90mm). To ensure the paper clamps (6)
hold the sandpaper, it should be longer than the base plate (8) (Approx 240x90mm).

The procedure for attaching the sandpaper is outlined below:

1. Soften the sandpaper by pulling it over the edge of a table or other straight

edge. Concentrate on softening the edges to be clamped.

2. Release paper clamp (6) by lifting the lever and disengaging it from the base

plate (8).

3. Insert the edge of the sandpaper under the front paper clamp (6). Close the

clamp to secure the paper.

4. Wrap the sandpaper around the rubber pad and insert the edge of the

sandpaper under the rear paper clamp (6). Close the clamp to secure the paper.

5. If you are using the dust extraction facility (9), make some perforations in the

paper in line with the holes on the rubber pad.

Dust Extraction

With the dust extraction facility supplied, you can attach the tool to most portable
vacuum cleaners. To utilise this facility, push the adaptor into the dust extraction
port at the rear of the sander. Fit the vacuum hose in or over the adaptor,
depending on the hose size.

Note: 

The dust extraction facility will only work when used with a vacuum cleaner

or dust extraction machine.  The sandpaper must be perforated, exposing the
holes in the base, to facilitate dust extraction.

!!