Fitting the tool rests
1. Assemble the tool rest by placing it
over the tool rest bar. The smaller,
slightly angled portion of the tool
rest should be closest to you and
facing down. The angle of the tool
rest should be adjusted according
to the application.
2. Feed one of the supplied bolts
through the tool rest bar and tool
rest. Place a flat washer and star
washer over the threaded end of the
bolt and secure by fastening tool
rest adjusting knob.
Note:
For the tool rest to work
effectively, it should be no more than
2 mm away from the grinding wheel.
This will also aid in the deflection of
stray sparks. As the wheel wears with
use adjust the tool rest accordingly.
Mounting the
bench grinder
For extra stability, we recommend
securing the bench grinder using
the mounting holes provided on the
corners of the base. Secure to a bench
or table using bolts or long screws (not
supplied).
On/Off switch
1. Turn the bench grinder on by pushing the
On/Off switch to the “I” (On) positiong. Once
depressed it will remain on.
2. Turn the bench grinder off by
pushing the On/Off switch to the
“O” (Off) position.
Grinding
1. Turn the bench grinder on and stand
to one side while the bench grinder
reaches maximum speed.
2. Place the workpiece onto
the tool rest.
3. Slowly guide the workpiece towards
the grinding wheel, ensuring that the
workpiece is at the desired angle
when it makes contact.
4. Apply gradual pressure to allow the
wheel to warm up evenly. Use only the
pressure required to complete the job.
5. By moving the work piece back and
forth across the wheel you will prevent
grooves.
2. OPERAtiON
OPERATION
2 mm
Max.
WARNING!
DO NOT GRIND WITH THE EYE SHIELD
RAISED: ALWAYS WEAR SAFETY GLASSES WHEN
OPERATING THE bENCH GRINDER.
WARNING!
THE POWER SUPPLY FOR THIS
PRODUCT SHOULD bE PROTECTED bY A
RESIDUAL CURRENT DEVICE (RATED AT 30MA OR LESS).
A RESIDUAL CURRENT DEVICE REDUCES THE RISK OF
ELECTRIC SHOCK.
