9
Depress the switch to start the drill.
Move the drill bit into the work piece applying only enough pressure to keep the bit cutting.
Note:
Do not force the drill or apply side pressure to elongate a hole. Let the drill and
bit do the work.
Helpful Tips
When drilling hard, smooth surfaces, use a centre punch to mark the desired hole
location. This measure will prevent the drill bit from slipping off centre as you start the
hole. However, the variable speed feature allows you to start holes without centre
punching. To accomplish this, operate the drill at a low speed until you start the hole.
When drilling metals, use light oil on the drill bit to keep it from overheating. The oil will
prolong the life of the bit and increase drilling action.
If the bit jams in the work piece or if the drill stalls, stop the tool immediately. Remove
the bit from the work piece and determine the reason for jamming.
•
Keep the ventilation slots of the hammer drill clean at all times and prevent any
foreign matter from entering.
•
If the housing of the hammer drill requires cleaning, do not use solvents but a
moist, soft cloth only.
•
Never let any liquid get inside the tool. Never immerse any part of the tool into a
liquid.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repairing of the hammer drill by an unauthorised person or by mishandling of the tool.
OPERATION (cont.)
MAINTENANCE
