SAFETY INSTRUCTIONS FOR SILENT SHREDDERS
6
•
Only use the shredder in dry conditions and never outdoors when it is raining.
•
Do not allow children or any person who has not read this instruction manual or
who is not familiar with the shredder, to operate it.
•
Remember that the operator may be held responsible for accidents or hazards
occurring to other people and/or their property.
•
Only use the shredder in dry conditions and never outdoors when it is raining.
•
Ensure the shredder is placed on a firm and level surface prior to using.
•
Before starting the shredder, ensure that the chute is empty.
•
Never use the shredder with damaged safety devices or without protection.
•
Never operate the shredder unless the chute is in place and securely fastened.
•
Wear ear protection when operating the shredder.
•
Never look directly into the outlet while the shredder is running as loose debris
may be ejected.
•
Do not allow processed material to build up in the discharge chute. This may
prevent proper discharge and can result in kickback of material through the
feeding hopper.
•
If the machine becomes clogged, switch off the machine and disconnect from
power. Allow the cutter to come to a stop. Clear debris from the cutter assembly.
•
Never attempt to shred bones, stone, glass, metals, plastic or rags.
•
Ensure all customer assembled hex-screws and nuts are properly tightened
before use.
•
Wear protective gloves, safety glasses and avoid loose clothing.
WARNING! Rotating cutter head. Keep hands and feet out of openings.
•
Store shredder upright in a dry place when not in use.
•
Never put your hands in the cutter area while the cutter assembly is running or
the shredder is plugged in. The cutter continues to run for a few seconds after
the shredder has been switched off.
•
If the cutter strikes any foreign objects or if the shredder starts making any
unusual noise or vibration, switch off the shredder immediately and disconnect
the power. Allow the cutter to come to a stop and take the following steps:
-
inspect for damage.
-
check and tighten any loose parts.
-
have any damaged parts replaced and/or repaired by an electrician or
power tool repairer.
•
Always switch off the shredder and disconnect the power whenever you leave
the work area.
Summary of Contents for OZSS2400WA
Page 12: ...11 LABELS ON YOUR TOOL ...
