INTRODUCTION
SAFETY INSTRUCTIONS
3
Warning!
When using mains-powered tools, basic safety precautions, including
the following, should always be followed to reduce risk of fire, electric shock,
personal injury and material damage.
Read the whole manual carefully and make sure you know how to switch the tool
off in an emergency, before operating the tool.
Save these instructions and other documents supplied with this machine for
future reference.
The electric motor has been designed for one voltage only. Always check that the
power supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.
This tool is double insulated in accordance with EN 50144; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced by an electrician or
power tool repairer in order to avoid a hazard.
Note:
Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective. When using an extension lead
on a reel, always unwind the lead completely. Use of an extension lead not suitable
for the power input of the tool or which is damaged or defective may result in a
risk of fire and electric shock.
Congratulations on purchasing an Ozito Silent Shredder. We
aim to provide quality tools at an affordable price. We hope
you will enjoy using this machine for many years.
Your Silent Shredder OZSS2500WA has been designed for
shredding organic material such as dry plant residue, twigs,
sticks and branches up to 40mm thick. It is intended for DIY
use only.
ELECTRICAL SAFETY
