5. FUNCTIONS
6. DRILLING
FWD
REV
3
3
Drilling
1 To drill into wood, metal or plastic,
turn the function collar to the align
the arrow on the housing with the
drill icon.
Screwdriving
Hammer Drilling
1 To screw into wood, metal or
plastic, turn the function collar to
the align the arrow on the housing
with the screw icon.
The clutch is then enabled to
adjust torque.
1 To drill into concrete, brick or
other masonry, turn the function
collar to the align the arrow on
the housing with the hammer
icon.
Before starting to drill, perform a few simple checks.
3 Secure the material to be drilled in a vice or clamp to stop it turning whilst
drilling.
1 Depress and release the variable
speed trigger to ensure it is not
locked on.
4 Hold the drill firmly and place the
bit at the point to be drilled.
2 Check the function selector
and forward/reverse lever is on
desired setting.
5 Depress the variable speed
trigger to start the drill.
6 Move the drill bit into the workpiece.
Note:
Do not force the drill or apply side pressure to elongate the hole. Let
the drill do all the work.
2 To adjust the torque, rotate the torque collar to the desired setting.
Note:
Selecting a higher torque setting will allow the drill to use more torque to drive
the screw in or out. To prevent damaging the screw head, it is recommended to
start at a low torque setting and increase when necessary.
PXBHS-100
