ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
KNOW YOUR PRODUCT
SETUP & PREPARATION
1. DEPTH & BEVEL ADJUSTMENT
1. Hex Key Holder
2. Dust Port
3. Safety Switch
4. On/Off Trigger
5. Blade Change Lever
6. Front Handle
7. Rear Bevel Locking Knob
8. Saw Blade
9. Front Bevel Locking Knob
10. Cutting Line Guide
PLUNGE SAW
1
2 3
4
5
6
7
8
9 10
11 12
13
15
16
17
14
B
A
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Cutting Depth Adjustment
Bevel Adjustment
¥
Cutting depth
A
shows the cutting depth
WITHOUT
Guide
rail fitted.
¥
Cutting depth
B
shows the cutting depth
WITH
guide rail
fitted.
1. Loosen the Cutting Depth
Knob.
1. Loosen both Bevel Locking
Knobs.
3. Tighten Bevel Locking
Knobs.
2. Press the Knob inwards and slide to set the desired depth
using the Cutting Depth Scale.
2. Align Base Plate to desired
angle on Bevel Angle Scale.
Depth should be adjusted so that no more than one tooth
is protruding through the timber. This helps to minimise
splintering.
11. Cutting Depth Scale
12. Bevel Angle Scale
13. Cutting Depth Knob
14. Base Plate
15. Blade Locking Lever
16. Guide Rail Adjusting Knob
17. Rear Handle
3. Tighten Cutting Depth Knob.
B
A
