2. CONTROLS
3. CUTTING GUIDES
The cutting guide will give an approximate line of cut. For a
straight cut, use the 0° notch. For a 45° cut, use the 45° notch.
OPERATION
WARNING!
THE TOOL IS RECOMMENDED FOR USE WITH
A RESIDUAL CURRENT DEVICE WITH A RATED RESIDUAL
CURRENT OF 30mA OR LESS.
WARNING!
AFTER USE, HOLD THE SAW AWAY FROM
YOUR BODY UNTIL THE BLADE STOPS COMPLETELY.
B
A
0
10
20
30
40
50
Turning On and Off
Cutting Line Guide
Using the Guide Rail
Note:
Allow the saw to reach full speed before beginning a cut.
1. Slide and hold the Safety Switch then squeeze the On/Off
Trigger to start the saw.
2. Slide on the second Guide Rail fully into position and tighten
in place.
1. To connect two rails, slide the Joiner into the notch on the
underside of one Guide Rail then tighten the screws with the
small (3mm) Hex Key provided.
2. To stop the saw, release
the On/Off Trigger.
0º
45º
B
A
0
10
20
30
40
50
Note
:
Additional Guide Rails may be assembled if required by
following the above steps.
3. Place the
Plunge Saw in
the Guide Rail.
Note
:
In confined spaces using one 700mm guide rail is ideal.
Guide Rail Adjustment
Tighten or loosen the Adjusting knobs to minimise or increase
the clearence between the plunge saw and the guide rail.
B
A
0
10
20
30
40
50
