OPERATION (cont.)
12
Mulching Palm Fronds
The shredder can shred palm fronds, reducing them to an easily disposable waste.
If the head of the palm frond is particularly large or hard it will need to be
removed before being inserted into the shredder.
If the material is very hard the cutting adjustment bolt (4) may need to be adjusted
as described in “Prior to operation” and run through the shredder once to soften
it. Retighten the cutting adjustment bolt and insert the material a second time to
effectively shred it.
Composting
The shredded material can be composted in many various ways:
•
The material can be placed in a heap directly on the ground (cold composting).
•
The material can be placed in a plastic container, wooden crate, skeleton
container or similar (cold composting).
•
The material can be placed in an insulated compost holder. The heat is then
maintained for longer periods and the rotting process continues during the
winter. This method produces faster results (warm composting).
•
The material can be spread directly onto the garden (surface composting).
WARNING!
Always use a dust mask and safety gloves when handling
composted material to prevent contamination from micro organisms.
WARNING!
Always disconnect the shredder from the power supply
before performing any maintenance.
The shredder requires very little maintenance. In order to maintain the efficiency of
the machine and achieve a long service life observe the following:
•
Keep the air openings clean and free of obstructing material.
•
Periodically check that all nuts and screws are secure.
•
Spray the rolling cutter head after each use with a spray lubricant to protect
against corrosion.
•
Always clean the shredder after each use. Brush away dirt and plant residue
which may be caught in the roller cutter. Wipe clean the outside of the shredder
with a cloth which has been moistened with a mild detergent and water.
•
Store the shredder upright in a dry place.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
the repair of the tool by an unauthorised person or by mishandling of the tool.
MAINTENANCE
!
!
