4. PREPARATION
5. CONTROLS
OPERATION
PRESS
Inserting the Batteries
Only use 2 batteries with the same capacity and charge state with the blower
vacuum-mulcher.
Slide two batteries of the same
capacity and same charge state
into the battery mount aligning
the ribs so that they click into
place.
Removing the Batteries
Press and hold the battery
release tab to release a battery
and slide the battery out.
PRESS
Note:
For best performance use only batteries which are charged to the
same level. Never combine full and half-full batteries as the equipment‘s
operating time depends on the battery with the lower charge level.
Shoulder Strap
Slip the shoulder strap over your
shoulder and adjust the length of
the strap so that you can handle the
equipment comfortably.
To quickly unclip, press either side of
the buckle.
Additional Handle
Loosen the knob to rotate handle to
the desired position, retighten knob to
secure in place.
LOOSEN
On/Off Switch
1. To switch ON, push the on/off
switch to the “I” position.
O
O
1. To switch OFF, push the on/off
switch to the “O” position.
O
O
Note:
There are a number of safety switches for preventing the unsafe
operation of this machine. Ensure the machine is fully assembled in either
Blower or Vacuum-Mulcher mode setup, otherwise it will not be possible to
switch on the machine.
Power Setting Adjustment
This blower vac is fitted with a variable speed dial and turbo speed button.
Varying the speed provides greater control when using the blower vac,
the blowing velocity and suction power can be adjusted depending on the
application.
- Variable Speed Dial
To adjust the air speed rotate the
variable speed dial.
The dial is numbered “1” to “MAX”.
Setting to “1” provides the slowest
air speed, setting to “MAX” provides
the fastest air speed.
- Turbo Speed Button
To increase air speed for a short
period, press the “Turbo” button.
Use the variable speed dial only with the speed which is actual required and
do not let it run at a speed which is faster than necessary.
If you need higher blowing power or suction power for a short time, you can
press the turbo button. Pressing the turbo button increases the speed for a
short time and with it the blowing or suction power.
Note:
Never press the Turbo button
for any longer than necessary, in order
to keep the noise level down and
extend the battery operating time.
