3. CONTROLS
OPERATION
Variable speed Trigger
forward/Reverse lever
3 Control the speed by adjusting the
amount of pressure applied to the
trigger.
2 To remove screws and bolts, push
the fwd/rev lever hard right.
1 To start the driver, squeeze the
variable speed trigger.
2 Release the variable speed
trigger to stop the driver.
1 To drive screws and bolts, push
the fwd/rev lever hard left.
REV
FWD
4. DRIVING PROCEDURE
pXIDs-300
Note:
Do not force the driver or apply side pressure to elongate the hole.
Let the impact driver do the work.
2 Check the forward/reverse lever
is on desired setting.
5 Lightly squeeze the variable
speed trigger to start the driver.
1 Depress and release the on/off
trigger to ensure it is not locked.
4 Hold the driver firmly
against the fastner to
stop it slipping.
3 Ensure the work piece is secured
to stop it turning whilst driving.
6 Slowly increase pressure
on trigger to appropriate
torque for circumstances
until screw or bolt is
tightened.
REV
FWD
Slower Faster
PXDDK-301
