FWD
3. KEYLESS CHUCK
4. CONTROLS
OPERATION
Speed Control
1. Slide the switch backward
to select first gear.
2. Slide the switch forward to
select second gear.
The gear selector controls the speed of the drill. First gear allows
slower drilling with more torque, while second gear is suitable when
less torque but higher speed is required.
Forward/ Reverse Lever
Variable Speed Trigger
1 For forward rotation, push the fwd/rev lever towards the left side of
the drill. For reverse rotation push fwd/rev lever to the right. The LED
at the rear of the drill will also indicate direction.
1 To start drilling squeeze the
variable speed trigger.
2 To stop drilling release the
trigger.
Note:
The more the variable speed trigger is depressed, the faster the
drill bit will rotate.
Adjusting Torque
1 Rotate the torque collar to the desired setting.
Note:
Selecting a higher torque setting will allow the drill to use more
torque to drive the screw in or out. To prevent damaging the
screw head, it is recommended to start at a low torque setting
and increase when necessary.
Installing a Drill Bit
Removing a Drill Bit
1 Open the chuck by
rotating the chuck collar
and remove the frill bit.
2 Insert the drill
bit, making sure
it is centred in
the chuck.
4 Pull on the bit
to ensure it is
firmly secured.
CAUTION:
TO REDUCE THE RISK OF INJURY WE
RECOMMEND THE USE OF GLOVES WHEN HANDLING
DRILL BITS.
1 Rotate the chuck collar
anti-clockwise to open the
chuck
3 Tighten the chuck by
turning clockwise.
WARNING!
Ensure the tool is turned off & disconnected
from the power supply before performing any of the following
operations.
