Ozito PXIDS-300, Instruction Manual

3.  CONTROLS

OPERATION

Variable Speed Trigger

Forward/Reverse Lever

3   Control the speed by 

adjusting the amount of 

pressure applied to the 

trigger.

2   To remove screws and 

bolts, push the fwd/rev 

lever hard right.

1   To start the driver, squeeze 

the variable speed trigger.

2   Release the variable speed 

trigger to stop the driver.

1   To drive screws and bolts, 

push the fwd/rev lever hard 

left.

REV

FWD

4.  DRIVING PROCEDURE

PXIDS-300

Note:

 Do not force the driver or apply side pressure to elongate 

the hole. Let the impact driver do the work.

2   Check the forward/reverse 

lever is on desired setting.

5   Lightly squeeze the 

variable speed trigger to 

start the driver.

1   Depress and release the 

on/off trigger to ensure it is 

not locked.

4   Hold the driver 

firmly against the 

fastner to stop it 

slipping.

3   Ensure the work piece is 

secured to stop it turning 

whilst driving.

6   Slowly  increase 

pressure on trigger 

to appropriate 

torque for 

circumstances until 

screw or bolt is 

tightened.

REV

FWD

Slower Faster