Jammed Staple or Nail
1. Press the cartridge latch down and pull the magazine slider out of the
tool.
2. Using a pair of pliers, remove any jammed staples or nails.
3. With the magazine still open, tap
the safety striker guard against
a surface to dislodge any loose
staples.
4. If the tool is still jammed, remove
the rubber safety striker guard by
pulling downward while wiggling
side to side.
5. Use the hex key to loosen the
bolts on the top of the tool.
Note:
The bolts do not need to be
completely unfastened to remove
the nose plates.
6. Slide the two nose plates down
to algin the holes with the bolts,
then pull off, over the bolts.
7. Gently lift up the tongue and
dislodge any jammed fasteners
with tweezers or needle nosed
pliers.
8. To reassemble, fit in the reverse
order ensuring the nose plates
are flush with the mounting
plate and the safety pin is placed
correctly between the two nose
plates. Tighten the bolts and
reattach the rubber guard.
Note:
Ensure that the spring washers are positioned between the bolt
head and nose plate.
When not in use, the staple nail gun should be stored in a dry, frost free
location, keep out of children’s reach.
If the housing of the staple nail gun requires cleaning, do not use solvents.
Use of a cloth only is recommended. Never immerse any part of the staple
nail gun into liquid.
Note:
Ozito Industries will not be responsible for any damage or injuries
caused by repair of the staple nail gun by an unauthorised person or by
mishandling.
WARNING!
BEFORE CLEANING OR CARRYING OUT
ANY MAINTENANCE PROCEDURE, ENSURE THAT
THE BATTERIES HAVE BEEN REMOVED.
MAINTENANCE
DESCRIPTION OF SYMBOLS
V
Volts
mm
Millimeters
A
Amperes
/min
Per minute
Warning
Read instruction manual
Wear ear & eye protection
Regulatory Compliance Mark (RCM)
Power tools that are no longer usable should not be disposed
of with household waste but in an environmentally friendly
way. Please recycle where facilities exist. Check with your local
council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquiries@ozito.com.au
SPRING WASHER
NOSE PLATE
BOLT
NOSE PLATE
5. TROUBLESHOOTING
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Short Battery Runtime
Ensure the battery is properly charged. It will take 4-5 charging cycles
before the battery reaches optimum charge and run time.
