2. BATTERY INSTALLATION
Battery Charge Indicator
The purchased battery is equipped
with a battery charge indicator to
show the state of the battery charge.
Press the charge indicator button and
look to see which LED lights.
Battery requires
immediate charging
Low state of charge, requires charging soon.
Mid state of charge
Full state of charge.
Note:
The battery needs to be removed from the tool to check the state
of charge.
1 Connect the charger into a mains power outlet.
4 The charger LED will illuminate red signifying that the battery
is charging.
3 With the battery sitting on a flat
surface, align the raised ribs
on the battery with the recess
in the charger and slide onto
the battery ensuring a firm
connection.
2 The charger LED will flash
green showing power
is being supplied to the
charger.
5 When removing the charger
from the battery, first press the
battery release tab, then slide
the charger from its position.
Charging your lithium ion battery - Eco Charger
Charger LED Indicator
LED Indicator
Situation
GREEN (Flashing)
Stand By (no battery pack is inserted)
RED (Illuminated)
Battery is charging (low charge)
GREEN (Illuminated)
Battery is fully charged
RED (Flashing)
Battery or Charger fault
RED & GREEN
(Flashing)
Battery pack is too hot or too cold (remove
battery from charger and store at room
temperature 20ºC. Insert battery again when
at correct charging temperature). If this
happens again, the battery is defective and
needs to be replaced.
Installing the Battery Pack
1 Holding the radio
housing, slide the
battery into the
base of the radio
until it clicks into
place.
Removing the Battery Pack
1 Press down
on the battery
release button.
2 Holding the radio
housing, slide
the battery pack
out.
