Jammed Staple
1. Press the cartridge latch down
and pull the magazine slider out
of the tool.
2. Using a pair of pliers, remove any jammed staples.
3. With the magazine still open, tap the safety striker guard against a
surface to dislodge any loose staples.
Short Battery Runtime
Ensure the battery is properly charged. It will take 4-5 charging cycles
before the battery reaches optimum charge and run time.
PXSGS-5021
4. CONTROLS
5. TROUBLESHOOTING
OPERATION
Firing A Staple or Nail
The Safety Striker System is a two step process where a staple will only fire
when the safety striker guard is pushed against the material to be fastened.
1. With one hand, push down on
the back of the tool to press the
safety striker guard down onto
the worksurface to be fastened.
2. To fire the staple gun, squeeze
the on/off trigger with your other
hand.
Staple Firing Force Adjustment
Some jobs require a lighter touch than others; reducing the force that
staples are fired at reduces the chance of damaging thinner more delicate
surfaces.
Note:
Always test the setting on a piece of scrap material after making
any adjustments.
1. To adjust the force of the staple
gun, turn the dial clockwise to
increase the strength.
2.
Turn the dial anti-clockwise to
decrease the strength.
Note:
If the staple is not fully
penetrating into the workpiece,
firmly hold down the staple gun
with two hands while firing.
a.
b.
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
WARNING!
ALWAYS USE BOTH HANDS WHEN
USING THE TOOL.
