6
ADDITIONAL SAFETY INSTRUCTIONS FOR ROTARY HAMMER DRILLS
This appliance is not intended for
use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Recommendations for the use of a residual current device
with a rated residual
current of 30mA or less.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric shock.
It is recommended that the extension lead is a maximum of 25m in length. Do Not
use multiple extension leads.
Before drilling into walls, ceilings etc, ensure there are no concealed power cables
or pipes in the cavity.
Always use the side handle, this gives you greater control if the accessory should
become jammed.
Keep the cord clear of the accessory being used, do not wrap the cord around your
arm or wrist.
Hold the tool by the insulated gripping surfaces when performing an operation
where the accessory may contact hidden wiring or its own cord.
Use thick cushioned gloves and limit the exposure time by taking frequent breaks.
Vibration caused by the hammer action may be harmful to your hands and arms.
When removing an accessory from the tool avoid contact with skin and use proper
protective gloves when grasping the bit or accessory. Accessories may be hot after
prolonged use.
Warning!
Some dust created by power sanding, sawing, grinding, drilling and
other construction activities contain chemicals known to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals are:
•
Lead from lead-based paints;
•
Crystalline silica from bricks, cement and other masonry products, and;
•
Arsenic and chromium from chemically-treated timber.
The risk from such exposures vary depending on how often you do this type of work.
To reduce your exposure to these chemicals; work in a well ventilated area, and work
with approved safety equipment, such as those dust masks that are specifically
designed to filter out microscopic particles.
Always wear eye protection and a dust mask for dusty applications and when
drilling/chiselling overhead. Sanding particles can be absorbed by your eyes and
inhaled easily and may cause health complications.
Special require:
•
Wear ear protectors. Exposure to noise can cause hearing loss.
•
Use auxiliary handles supplied with the tool. Loss of control can cause personal injury.
Summary of Contents for RHR-850
Page 1: ......
