9
•
Keep the ventilation slots of the reciprocating saw clean at all times. If possible
prevent foreign matter from entering the vents.
•
After each use, blow air through the saw to ensure it is free from all dust particles that
may build up. A build up of dust particles may cause the tool to overheat and fail.
•
If the enclosure of the reciprocating saw requires cleaning do not use solvents but
a moist soft cloth only. Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
•
When the carbon brushes wear out the tool will spark and/or stop. The brushes are
a wearing component of the tool and should be replaced prior to the carbon
wearing out fully. Brushes will wear out after many uses but before they do take
the tool to an electrician or a power tool repairer for quick and low cost
replacement. Always replace both brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the saw by an unauthorised person or by mishandling of the saw.
MAINTENANCE
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be
disposed of with household waste but in an environmentally
friendly way. Please recycle where facilities exist. Check with
your local council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
RSG-491K manual.QXD 2/4/10 2:53 PM Page 9
