Carbon brushes
When the carbon brushes wear out the tool will spark and/or
stop. Discontinue use as soon as this happens. They should be
replaced prior to recommencing use of the tool. Carbon brushes
are a wearing component of the tool therefore not covered under
warranty. Continuing to use the tool when carbon brushes need
to be replaced may cause permanent damage to the tool.
Carbon brushes will wear out after many uses but when the
carbon brushes need to be replaced take the tool to an electrician or a power tool
repairer for a quick and low cost replacement. Always replace both carbon brushes at
the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
the repair of the tool by an unauthorised person or by mishandling of the tool.
11
MAINTENANCE (cont.)
SPARE PARTS
Limited spare parts are available subject to availability. Please contact your local
Bunnings Special Orders Desk to order the required spare parts.
Most common spare parts listed below
Spare Part
Part No.
Collet Nut
SPRTP160-01
Carbon Brush & Brush Holder Set
SPRTP163-10
Switch
SPRTP163-15
4pcs Collet Set 1.5mm- 3.2mm
SPRTP163-601A
Spanner
SPRTP163-602
Flexible Drive
SPRTP163-1101
