ADDITIONAL SAFETY INSTRUCTIONS FOR ROTARY TOOL
7
This appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Recommendations for the use of a residual current device
with a rated residual
current of 30mA or less.
Do not use accessories (such as grinding discs) with a maximum rated speed
below 35,000/min.
Always wear eye, ear and breathing protection.
Do not apply too much pressure when grinding, cutting, etc.
Keep your hands well clear of the cutting devises.
Warning!
The use of an accessory or attachment, other than those recommended
in this Instruction Manual, may present a risk of personal injury.
To use this tool properly, you must observe the safety regulations, the assembly
instructions and the operating instructions to be found in this Manual. All persons who
use and service the machine have to be acquainted with this Manual and must be
informed about its potential hazards. Children and infirm people must not use this
tool. Children should be supervised at all times if they are in the area in which the tool
is being used. It is also imperative that you observe the accident prevention
regulations in force in your area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made to the tool nor for any
damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the tool’s construction
and design:
• Damage to the lungs if an effective dust mask is not worn.
•
Damage to hearing if effective earmuffs are not worn.
•
Damage to eyes if effective goggles are not worn.
•
Risk of injury unless hands are kept well clear of cutting devises.
